Instructions
Working off of a spool of 26-gauge artistic wire, place the warping wire against the button on the back of the Baby Jewel Loom® leaving a 3 in (7.6 cm) tail.
Wrap the wire around the button twice.
Pull the wire up and around the top of the loom. Let the wire settle into one of the grooves and pull it across to the other side of the Baby Jewel Loom.
Line the wire up with a groove on the other side, then wrap it around the second button.
Continue Steps 3 and 4, wrapping the wire around the button and across the length of the loom, skipping one groove each time, until you have as many warp wires as your design needs. This design uses 11 warp wires and size 6 seed beads.
Secure the warp wire behind the button and wrap around a few times to secure.
If necessary, use nylon jaw pliers to straighten your warp wires. Do this gently so you don't move any wires out of place.
Note: This design uses 11 wires, so it will require 10 beads. Always use one less bead than you have wires.
String your beads on a piece of 26-gauge artistic wire. Place the beads and wire underneath the warp wire. The tail will be on the right and the working wire should be on the left. Push the beads up through the wires so that one bead is between each wire and hold them in place with your index finger.
Carefully and gently thread the 26-gauge wire back through the row of beads from left to right - this creates the weft portion of the weave. Make sure that the weft wire passes back through each bead and the warp wires are sandwiched in between the weft wire.
Pull the weft wire tight.
You may need to use bent chain-nose pliers to grasp onto the wires to make sure that the weft is snug against the warp.
String up the next row of beads according to the pattern. Hold the beads in place behind the warp wires. Make sure each space has one bead.
Pull the weft wire tight against the warp wire.
Continue adding each row according to your pattern.
Row 4.
Row 5.
Row 6.
Row 7.
Row 8.
When you are finished with the pendant pattern, carefully snip the warp wires free from both sides of the Baby Jewel Loom.
Weave the weft wire back down along the side of the pendant so it is secure and out of the way.
To finish-off the design, add one seed bead to the 5th wire from each side as shown.
Add another bead over all three of the center wires.
Use round-nose pliers to make a wrapped loop with all three wires.
Use wire cutters to trim the wire from the loop.
Repeat Steps 22 - 25 to make matching loops on either side. You'll have one extra wire on each side. Bend this extra wire down to the side.
Weave the extra wire back and forth along the side of the pendant until you reach the middle to lock it into place.
Snip the excess wire as close to the pendant as possible and bend it into place with chain nose pliers.
Repeat Steps 22 - 25 to make matching picots on the other side of the pendant. Make sure these loops are all perpendicular to the pendant so you can thread a chain through them.
Bend down each of the remaining side wires and weave them back through the sides so that they meet the other woven in wires.
Snip the excess wire and tuck in the ends.
Have a question regarding this project? Email Customer Service.
All works of authorship (articles, videos, tutorials and other creative works) are from the Fire Mountain Gems and Beads® Collection, and permission to copy is granted for non-commercial educational purposes only. All other reproduction requires written permission. For more information, please email copyrightpermission@firemtn.com.