How to Use French Wire with Thread Jewelry Making Instructions

Use French wire to protect the thread from abrading as it passes over the loop on the clasp.

Instructions

Step 1

Cut a length of thread, 12 inches longer than the desired finished length of your design. Add the needle to one end.

Step 2

Cut two, 1/2 inch lengths of French wire.

Step 3

thread with french wire, leaving 3-inch tail

String the first bead in your design, one piece of French wire and the loop on one half of the clasp. Pass the needle back through the bead and pull the thread so there is a tail of thread about 3 inches long.

Step 4

Make a knot below the bead using the tail thread and the working thread.

Optional: Dot the knot with G-S Hypo Cement. Let dry, then trim any excess thread from the tail.

Step 5

Adding french wire to other end of design

After stringing the remaining beads in your design, add the second piece of French wire and the loop on the other half of the clasp. Pass the needle back through the last bead.

Step 6

Pull the thread, taking out any remaining slack. Make a half-hitch knot. Repeat, making a double knot.

Optional: Dot the knot with G-S Hypo Cement. Let dry, then trim the excess thread close to the knot.

Shop for Your Materials Here:

Thread No Category Name

Terminators No Category Name

Glues and Adhesives No Category Name

Clasps No Category Name

Have a question regarding this project? Email Customer Service.

Copyright Permissions

All works of authorship (articles, videos, tutorials and other creative works) are from the Fire Mountain Gems and Beads® Collection, and permission to copy is granted for non-commercial educational purposes only. All other reproduction requires written permission. For more information, please email copyrightpermission@firemtn.com.